A control panel for a small well?
Wastek Pro is designed to fit into small spaces. The peculiarity of this control panel is the possibility to use an air pressure sensor, particularly useful when the installation site is a small well.
Wastek Pro allows an accurate level detection from 0 to 100 cm and is expandable with a range of connectivity modules.
LCD display for displaying and programming: voltage, current, power factor, hours of operation, number of starts, motor status, alarms, sensor signal and thresholds
AUTOMATIC - 0 (standby) – MANUAL pushbuttons (fixed or pulse)
Language settings (Italian, English, French, Spanish, German)
Dry running protection by: level probes/floats/pressure switches and minimum current
Up to 4 control inputs: floats/pressure switches
Input for air sensor and 4-20 mA or 0-10V analogue signal
Unit of measurement of analog signal: centimetres or metres
Clicson inputs with automatic reset (can be disabled)
Inputs inversion (from normally open to normally closed)
Automatic reset from minimum current alarm settable with 4 programmable times
Start-up and shutdown delay time (programmable)
Maintenance time control (programmable
Pushbutton for manual operation (fixed or pulse)
Provision for run capacitors on single-phase model (not included)
ADDITIONAL FUNCTIONS WASTEK PRO 2
Duty/standby (can be disabled)
Immediate motor changeover in case of a fault
Power supply 1phase 100-240Vac 50/60Hz
Power supply 3phase 310-450Vac 50/60Hz
Electronic control of minimum and maximum voltage
Electronic control of maximum motor current
Electronic minimum motor current control
Failure or incorrect phase sequence control on power supply input (can be disabled)
Alarms reported: voltage status, levels, motor overload, minimum current, clicson motor
System maintenance warning
Alarm output contacts
Auxiliary and motor protection fuses
Isolator (except for NB code)
Box in ABS, IP55
AIR PRESSURE SENSOR
COSA NON PUÓ MANCARE
Variable buoyancy float with 20 meters of cable
UNIT ALARM 2
UNIT ALARM 2
UNIT ALARM 2 is a device applicable to any system where it is necessary to have audible and visual flashing alarm signals, even in the absence of mains power.
The app allows you to control and manage the operation of the switchboard directly from your smartphone, adding features such as an operating counter, start-up counter, ammeter, history of the last 20 alarms, input and output status, and the ability to manage dip-switches and trimmers from your smartphone, increasing calibration accuracy.
Float with 20m neoprene cable