Irigò
Electromechanical panels specific for irrigation systems.
The control panel specifically projected for irrigation systems. For single-phase or three-phase electric pumps with thermal
protection. The simple and efficient solution.
General features
-
Power supply 1~50/60 Hz 230V ±10% (IRIGò-Mono);
-
Power supply 3~50/60 Hz 400V ±10% (IRIGò-Tri);
-
Transformer 24 Vac for auxiliary circuit (IRIGò-Tri);
-
Auxiliaries contacts and circuits in low voltage;
-
Normally open contact for start;
-
Normally open contact for minimum level/pressure
contact; -
Green led indicating motor running;
-
Red led indicating motor overload;
-
Selector for Auto-Off-Manual (stable) operation:
-
Manual: direct operation without controls;
-
Automatic: operation controlled by min input and start
input;
-
-
Line contactor in AC3;
-
Overload thermal relay internally restorable;
-
Auxiliaries and motor protection fuses;
-
Box in ABS, IP55;
-
Ambient temperature: -5/+40 °C;
-
Relative humidity 50% at 40 °C (not condensed).
Highlights
Direct on line start type
The direct starting system is perhaps the simplest and most traditional and consists in connecting the engine directly to the power supply network, thus performing a full voltage start. It is often abbreviated with DOL (Direct On Line).
The DIRECTO electrical panel provides for direct connection to the power supply network which implies:
• Starting at full voltage and constant frequency
• High starting torque
• Very short acceleration times on average.
Applications
The cheapest and most simple DOL irrigation panel in electromechanical version.
Conceived for applications where it is required to protect the pump with a small expense.
Components
The IRIGò electrical panels are made in plastic boxes with a minimum protection degree of IP55.
The panel has a green light and a red light to signal pump operation or alarm status and a selector for manual or automatic operation.
A terminal block allows the connection to the utilities and external commands such as pressure switches, floats etc.