smart PRO
Want to optimize at low cost?
SMART PRO is the evolution of Elentek’s best-seller control
panel, suitable for both clean water and wastewater systems.
Thanks to the new expansion modules system and the connections, the panel can be used for a wide range of applications and increases the potential of the system.
Compact, very easy to install and program also by App, it facilitates the replacement of old and obsolete panels installed.
From 242 €
EASY INSTALLATION
USER INTERFACE
EXPANDABILITY
VERSATILITY
FUNCTIONS
LEDs on front of panel for signaling operating status and alarms
AUTOMATIC - 0 (standby) - MANUAL pushbuttons (fixed or pulse)
Anti-seize autotest (can be disabled)
Dry running protection with: level probes/ floats/ pressure switches
Up to 4 control inputs: floats/pressure switches
Clicson inputs with automatic reset (can be disabled)
Inversion of inputs (from normally open to normally closed)
Start/stop float switch function (can be disabled)
Current protection delay
Automatic reset from minimum current alarm (can be disabled)
Delay time of motor enabling after power mains return
Pushbutton for manual operation (fixed or pulse)
Predisposition for run capacitors for single-phase version (not included)
ADDITIONAL FUNCTIONS SMART PRO 2
Duty/standby (can be disabled)
Immediate motor changeover in case of a fault
VERSIONS
Power supply 1phase 100-240Vac 50/60Hz
Power supply 3phase 310-450Vac 50/60Hz
CONTROLS
Electronic control of maximum current with assisted calibration
Electronic control of minimum current (dry running) with assisted calibration
Failure or incorrect phase sequence control on power supply input (can be disabled)
ALARMS
Alarms reported: voltage status, levels, motor overload, minimum motor current, clicson motor
General alarm output contacts
PROTECTIONS
Auxiliary and motor protection fuses
Isolator (except for NB code)
Box in ABS, IP55
MAIN FEATURES
smart PRO
smart PRO
RS485
(Optional)
CLAMP EXTRACTABLE
EXPANDABILITY
MODULAR
KEY FEATURES
Electronic board
The electronic board of SMART PRO mounts an 8-switch dip-switch module to set the following modes of operation: level alarm signaling from probe input, amperometric protection trip delay, alarm output setting, alarm reset mode from motor clickson, fill/empty or pressurization operation mode, self-hold, and board activation delay from mains return.
Ammeter overcurrent protection and minimum current protection (dry run protection) is adjusted with trimmers on the board.
WHAT CAN'T MISS
APP
COD:
98107
The app allows you to control and manage the operation of the switchboard directly from your smartphone, adding features such as an operating counter, start-up counter, ammeter, history of the last 20 alarms, input and output status, and the ability to manage dip-switches and trimmers from your smartphone, increasing calibration accuracy.
