Drain
The control panel for sewage systems controlled by float switches
Drain is a specific control panel for sewage systems controlled by float switches.
General technical features
-
Control unit with Liquid Crystal Display to visualize:
-
voltage
-
frequency
-
current
-
operating status of the system
-
system faults
-
-
Controller: multilingual, sewage mode operation, digital ON-OFF input (float switches or external controls);
-
Auxiliary users activation in case of fault of the user in operation (2 pumps models);
-
Control of the users individually or in duty standby/assist (2 pumps models);
-
Electronic control of motor overcurrent;
-
Minimum voltage control : 180->415 (depending on the model);
-
Max voltage control: 220->460 (depending on the model);
-
Alarms control: motor in protection, motor overtemperature, board communication, voltage too low/
high, phase sequence/failure, min/max level; -
Alarms archive;
-
Isolator;
-
Box in ABS IP55;
-
Ambient temperature: -5/+40 °C;
-
Relative humidity 50% a 40 °C (not condensed).
Highlights
Electronic main board
DRAIN contains an electronic main board with microprocessor and external LCD for reading the parameters set and the alarms status.
The motor protection fuses are supplied as a standard and can be replaced by circuit breaker on request.
An isolator switch cuts the main power supply input to cut-off voltage to the panel and guarantees max safety when opening the control panel.
Main screens
The DRAIN series has a practical LCD display for reading the operating and alarm status, as well as a warning light to indicate the alarm status and programming and command keys on the frontpanel.
The main screen allows you to view the active motors, the input voltage and the total current consumption of the motors.
Set-up
The DRAIN range is designed for the use and control of drainage pumps managed by floats.
Any set-up, control and use operation is done on the frontpanel without the need to open the enclosure of the panel.
5 languages are available in the software (Italian, English, French, Spanish, German).
The system is simple, fast and intuitive.
Alarms
The DRAIN's electronic board has an alarm output with volt free contacts 5A – 250V.The messages of all the alarm status are shown on the display on the frontpanel: motor in protection, motor overtemperature, voltage too low, voltage too high, phase failure/sequence, max level, min level, boards communication.
Applications
_edited_jp.jpg)
Emptying/ Drainage
sewage water 1 pump
DRAIN 1 application for emptying/drenage of sewage water with float switches with trim variation (model DROP).
_edited.jpg)
Emptying/ Drainage
sewage water 2 pumps
DRAIN 2 application for emptying/drenage of sewage water with float switches with trim variation (model DROP).